This part is locked and cannot be edited. Click modify to make changes.
Specs that are affected by changes to the gear you're building.
The gear is being built. This can take anywhere from 10 seconds to a few minutes.
The next loading graphic may stop or skip, but that is just because the viewer is loading.
The first time you view a part it may take an extra
to load the viewer.
Please select a keyway position first.
Click the arrows to draw a keyway at that location. All of the keyways will be positioned based on the
Please select a setscrew position first.
Click the setscrew to highlight it at that location. All of the setscrews will be positioned based on the default.
Tooth forms in models and drawings are for representation only and should not be used for manufacturing purposes.
Rush Gears can supply accurate tooth profiles, models & manufacturing advice upon request for a nominal fee. Please contact our engineering department at
800-523-2576 or email us to discuss this service.
2D not available for custom parts.
Horsepower & Torque info for:
Type of Load:
Load in lbs @ pitch line:
Safe static stress:
Velocity (feet per minute):
Torque (inch lbs):
Information in this chart is to be used as a guide. Consult an engineer for more information. Backlash is ignored in this calculator.
All fields required except Fax
Parts for quotation
Would you like us to quote on manufacturing this part?
Most browsers have cookies enabled by default, however it looks like they are turned off in your browser.
Click this link to see how to enable cookies in your browser: http://www.wikihow.com/Enable-Cookies-in-Your-Internet-Web-Browser
If you think you have cookies turned on then just try refreshing this page. If cookies are set you won't see this message again. Thanks!!
Please send me an email if you have any problems website help.