Please let us know if you are having a problem with this application. Or, if there is
something you would like us to add or change feel free to suggest it here.
Click + Create New Part to start building a gear, or open one from My Parts.
This part is locked and cannot be edited. Click modify to make changes.
Gear
Size & Hubs
Counterbores
Keyways ()
Setscrews ()
Tap a keyway position on the gear first.
Click the arrows to draw a keyway at that location. All of the keyways will be positioned based on the
default. <more>
Tap a setscrew position on the gear first.
0 setscrew(s)
Click the setscrew to highlight it at that location. All of the setscrews will be positioned based on the default.
<more>
D Bores
Calculated from your gear
Worm and worm gear models are still in beta mode.
If you have any problems please email us at websitehelp@rushgears.com. Hours 8am-5pm EDT.
***Do not use this email to request a quote***
The gear is being built. This can take anywhere from 10 seconds to a few minutes.
The next loading graphic may stop or skip, but that is just because the viewer is loading.
The first time you view a part it may take an extra
20-30 seconds to load the viewer.
Tooth forms in models and drawings are for representation only and should not be used for manufacturing purposes.
Rush Gears can supply accurate tooth profiles, models & manufacturing advice upon request for a nominal fee. Please contact our engineering department at
800-523-2576 or email us to discuss this service.
Download part#
2D is not available for this part.
Horsepower & Torque part#
← edit me
Load in lbs @ pitch line
Safe static stress
Velocity (feet per minute)
Horsepower
Torque (inch lbs)
Strength Factor
Service Factor
Information in this chart is to be used as a guide. Consult an engineer for more information.
Backlash is ignored in this calculator.
Parts To Quote
(0)
Request a Quote
1 Parts & quantities
Part#
Quantity
Remove
You must enter a quantity for each part.
2 Your information
All fields are required except Fax.
Contact Preference
Parts for quotation
Would you like us to quote on manufacturing this part?
Enter your email address
My Parts for
My Saved Parts
Saved
For this page to work properly it requires the use of cookies.
Most browsers have cookies enabled by default, however it looks like they are turned off in your browser.
Click this link to see how to enable cookies in your browser: http://www.wikihow.com/Enable-Cookies-in-Your-Internet-Web-Browser
If you think you have cookies turned on then just try refreshing this page. If cookies are set you won't see this message again. Thanks!!
Please send me an email if you have any problems website help.
